how measure throat opening on hook

OzBlok Chain block Manual
Measure the opening of the hook's throat and illustrate it with the letter "E." This shows how big the hook opening is, and what size bucket handles or lanyard rings will fit into.
Item # 14-350-06, 3/4" Self Locking Snap.
Look for wear in the saddle of the hook, cracks, severe corrosion, and twisting of the hook body. Be especially careful to measure the throat opening.
HOIST LOAD TEST REPORT
View item # 14-539-46, 2 2/2' Self Locking Rebar Snap Hook. 2 1/2" (64mm) minimum throat opening; 8 7/8" (225mm) length end to end: Unit of Measure: Imperial | Metric | Both
Product Catalog - Rigging Hardware.
Then inspecting Salesman will need to determine the " Throat" opening dimension.. side to the other and may be obtained by placing a ruler or tape measure in front of the Hook.
Item # 14-539-46, 2 2/2" Self Locking.
... the shank or eye and the other on the hook up, which allows for a QUIC-CHECK measurement to determine if the throat opening has. measuring device (i.e. tape measure) to measure.
Kennedy Wire Rope & Sling, Co.
Measure reach accurately (bearing point of master ring to bearing. the unbent hook, unless otherwise directed by the hook manufacturer. Throat Opening .
Page 1 of 1
... Deformation HOOK INSPECTION Cracks (dye penetrant, magnetic Where applicable, inspect hooks and measure throat opening.
Whiting ServiceS , i
... the shank oeye and the other on the hook up. use a measuring device (i.e. tape measure) to measure the distance between een QUIC-CHECK® meato determine if the throat opening has.
Item # 1024420 on American Wire Rope.
If wire rope is used, then measure the. Inspector Verify _____ Throat Opening. SUSPENSION HOOK : Qualified Inspector Verify _____ Throat Opening _____ _____.
WARNING AND APPLICATION INSTRUCTIONS
A tape measure having a molded plastic hook with a hook member. measuring tape blade, the tape measure having a measuring tape blade delivery throat with an outer opening in.
Seatrax Inc. Offshore Cranes Rigging.
Never use a hook whose throat opening has been increased, or whose tip has been. With one split nut half seated against the hook shank, push the nut to one side and measure the.
How to Measure a J Bolt | eHow.com
To check , use a measuring device (i.e., tape measure) to measure the distance. Never use a hook whose throat opening has been increased, or whose tip has been bent more than 10.
CROSBY® / BULLARD® GOLDEN GATE® HOOK WARNING AND APPLICATION.
To check, use a measuring device (i.e., tape measure) to measure the distance. Never use a hook whose throat opening has been increased, or whose tip has been bent more.
Crane Hook Safety Latches - 5 Important.
Measure hook for hook throat spread before and after load test. Establish. points before and after load test. An increase in the throat opening by
lm5
09.04.2010 · ... HOOK INSPECTION Cracks (dye penetrant, magnetic Where applicable, inspect hooks and measure throat opening at least once a month.